P1 20W
Engraving Parameters
| Material | Power（%） | Speed（mm/min） | NOTE |
|---|---|---|---|
| leather | 15 | 2000 | The parameters will vary according to the material color. |
| Basswood | 20 | 3000 | |
| aluminumsheet | 80 | 2000 | |
| Ceramic | 30 | 3000 | The surface needs to be heat transfer paper applied.This parameter is obtained when the ceramic surface is attached with colored paper. |
| Kraft paper | 10 | 3000 | |
| Acrylic | 30 | 2000 | For transparent surface need to be painted black. |
| Stainless steel | 100 | 2000 |
Cutting Parameters
| Material | Thickness | Power（%） | Speed（mm/min） | Pass | NOTE |
|---|---|---|---|---|---|
| Acrylic | 30mm | 100 | 100 | 30 | Non transparent black acrylic plate is recommended. |
| Acrylic | 4mm | 100 | 300 | 3 | Non transparent black acrylic plate is recommended. |
| Basswood | 2mm | 100 | 700 | 1 | With air assist |
| Basswood | 4mm | 100 | 350 | 1 | With air assist |
| Basswood | 5mm | 100 | 300 | 1 | With air assist |
| Basswood | 8mm | 100 | 120 | 1 | With air assist |
| Basswood | 20mm | 100 | 500 | 8 | With air assist |